Tools needed: 8mm T Wrench, Park tool CCP-2 Crank Puller.
Instructions: Remove the 8mm screw, and then use the park tool CCP-22 to remove the crank and/or crank arm from the bottom bracket of the bike. Once removed, slide the new cranks set into place, and make sure each side is installed in the opposite direction of its counterpart EX. left side up, right side down. Tighten up each side with the 8mm screw, and 8mm T wrench. Be sure each side is tight to avoid any potential loosening of the bolts.
Comments
0 comments
Please sign in to leave a comment.